920, 921, 922, 923, 924 or 925 Fuser Error on LCD Panel [ Dell 5210n , 5310n Printers ]

920, 921, 922, 923, 924 or 925 Fuser Error on LCD Panel [ Dell 5210n , 5310n Printers ]


920 921 922 923 924 925, fuser error on lcd panel 5210n , 5310n, printers 

  1. Perform a power on reset of the printer.
    1. Turn the printer off.
    2. Disconnect the power and data cables from the printer.
    3. Wait at least five seconds.
    4. Reconnect the power and data cables of the printer.
    5. Turn the printer on.

  2. Ensure that the correct power requirements for laser printer are met.
    • Always review the Owner's Manual of the Laser printer to determine the maximum wattage of the printer while printing.
    • Always try to plug the laser printer directly to a wall outlet.
    • Avoid plugging the laser printer into a power strip shared by other devices.
    • Ensure that other outlets on the same circuit do not have “high power demand” devices in operation. Usually, one circuit breaker provides power to several outlets.
    • NEVER plug a laser printer into an Uninterruptible Power Supply (UPS) system. The power demands of a laser printer are usually not compatible with the capabilities of small home and business UPS systems.

  3. Download and install updated firmware for Dell 5210n/5310n laser printer.

  4. Verify if the paper size and type settings in the operator panel matches the print media size and type being used on the printer.
      1. Press the Menu button.
      2. Press the Select button to select Paper Menu.
      3. Press the down arrow until Paper Size/Type appears and press Select.
      4. Press the down arrow until the specified tray appears. Then press the Select button.
      5. Open the paper tray.
      6. Verify the paper stop slider is set to the same paper size as the operator panel.
      7. Press the Select button.
      8. Verify the paper type in the tray is the same as the paper type in the operator panel.

  5. Determine if the fuser has been replaced for this issue.
    • The fuser has not been replaced: Replace the Please contact Dell Technical Support for further advice.
    • The fuser has been replaced: Please contact Dell Technical Support for further advice.
 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN162455

Last Date Modified: 07/29/2013 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.