How To Remove And Install The Toner Cartridge On A 2335dn Dell Laser Printer

How To Remove And Install The Toner Cartridge On A 2335dn Dell Laser Printer


Article Summary: This article explains how to remove and install the toner cartridge on a 2335dn Dell Laser Printer

Table of Contents:

  1. Installing The Toner Cartridge
  2. Remove and Reseat The Toner Cartridge



Installing The Toner Cartridge





To prevent damage, do not expose the toner cartridge to light for more than a few minutes

Do not touch the green underside of the toner cartridge. Use the handle on the cartridge to avoid touching this area


If toner comes into contact with your clothing, wipe the toner off with a dry cloth and wash your clothing in cold water. Hot water sets toner into fabric.



  1. Open the front cover
  2. Remove the toner cartridge from its bag and thoroughly shake the cartridge from side-to-side to distribute the toner evenly inside the cartridge
  3. Holding the toner cartridge by the handle, slide it into the printer until it locks firmly into place
  4. Close the front cover

Back to Top


Replacing The Toner Cartridge

When the toner eventually runs out, only blank pages print when a print job or copy job are sent. The LCD displays the warning message, Toner Almost Empty Replace Toner. In that case the incoming faxes are only saved in the memory and not printed. At this stage, the toner cartridge needs to be replaced.

Order an extra toner cartridge so you will have it on hand when the current cartridge no longer prints satisfactorily. See Ordering Supplies to order toner cartridges

For best results, use Dell toner cartridge. Print quality and printer reliability are not guaranteed if you do not use Dell supplies.


To replace the toner cartridge:




Save the box and the cover for shipping

If toner comes into contact with your clothing, wipe the toner off with a dry cloth and wash your clothing in cold water. Hot water sets toner into fabric.

Do not touch the green underside of the toner cartridge. Use the handle on the cartridge to avoid touching this area.
  1. Open the front cover
  2. Pull the toner cartridge out
  3. Remove the new toner cartridge from its bag
  4. Remove the packing tape and thoroughly shake the cartridge from side-to-side to distribute the toner
  5. Holding the toner cartridge by the handle and slowly insert the cartridge into the opening in the printer
  6. Tabs on the sides of the cartridge and corresponding grooves within the printer will guide the cartridge into the correct position until it locks into place completely
  7. Close the front cover. Ensure that the cover is surely closed

Back to Top





Article ID: SLN285026

Last Date Modified: 12/10/2019 09:04 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.