SCCM E Series NIC driver import issue

SCCM E Series NIC driver import issue


Note: This issue has been corrected with an updated driver release. Please download the latest driver if you are experiencing the issue below.

The Intel NIC drivers for the E-Series notebooks have not been importing correctly into SCCM's OSD due to some missing PNPIDs in the INF files for Vista32 and Vista64. The error in the OSD import is "The selected driver is not applicable to any supported platforms." (See screenshot below.)


The corrected INF files attached below will address this issue. Replace the corresponding files in your NIC driver source files before importing, and they will import correctly. (See screenshot below.)

Use the updated INF files as a workaround until the issue is corrected in a future release of the drivers.

E1y606x64.inf
E1y6032.inf

These updated INF files were used with driver downloads R204518 (Vista32) and R204519 (Vista64), which will show in SCCM as version 9.50.14.2 of the "Intel­® 82567LM Gigabit Network Connection" driver. You will need to include this driver in your WinPE boot image.

To extract these drivers for import use the /s /e=<path> command-line switches. The files you need for import are in the payload folder and replace the appropriate INF file.

SCCM
Figure 1: INF File
SCCM
Figure 2: Import New Driver


Article ID: SLN310394

Last Date Modified: 08/14/2018 03:29 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.