Unattended Auto installation of SLES12 using LC

Unattended Auto installation of SLES12 using LC


Generally the LC is used to install the OS along with latest driver/firmware available for the particular platform/OS.

Till date there was no facility available to do unattended OS installation using the LC, but this is possible in SLES12.

This can be achieved in two different ways.
  • The user can use the default autoyast.xml file for deployment which is created by LC.
  1. Enter into F10 or Lifecycle Controller & select the OS deployment under, & select the desired OS for installation.
  2. LC will create a OEMDRV partition along with drivers & autoyast.xml file.
  3. Boot into the OS DVD or ISO.

Or
  • The user has to follow these four steps to have a customized autoyast.xml during the SLES12 deployment using LC.
  1. Prepare an autoyast.xml which is a kick start file for unattended SLES12 installation.
  2. Enter into F10 or Lifecycle Controller & select the OS deployment under, & select the desired OS for installation.
  3. Place the autoyast.xml file in OEMDRV partition which is created by LC.
  4. Boot into the OS DVD or ISO.


The SLES12 has a New implementation in New Yast installer that it tries to detect the autoyast.xml file in block device which is having a label name "OEMDRV" during the boot,

Unattended Auto installation

due to this the SLES12 installer kicks the unattended installation if autoyast.xml file is available in OEMDRV.


Article ID: SLN310803

Last Date Modified: 08/13/2018 08:09 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.