OptiPlex 760 BIOSes

OptiPlex 760 BIOSes


The OptiPlex 760 BIOS update package is a legacy BIOS update package. See that page for command line options. See the passwords section on that same page for more information on performing BIOS updates when a BIOS password is set.

Updates

Updates

Known Issues

  • When applying a BIOS update, if a BIOS password is set after the update but before the system reboots, then the update will fail. During boot the failure message is "Could not find the firmware image in memory" and the BIOS completion code value is 000D. See this thread. The BIOS password should not be set until after the system reboots from the BIOS update.



Article ID: SLN310842

Last Date Modified: 08/16/2018 04:31 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.