How to set a username and password for Web, Telnet access on PowerConnect and N series switches.

How to set a username and password for Web, Telnet access on PowerConnect and N series switches.




Article Summary: This article explains the command needed to set up a username and password for HTTP and/or Telnet access to the PowerConnect switches.



To configure a username and password for Web GUI or Telnet access, run the following commands.

This is an example with the username as Dell, and password as PowerConnect. These are just examples and you should use more complicated, hard to guess credentials to secure your switch.


console>enable

console#configure

console(config)#username Dell password PowerConnect level 15

Note: For the PowerConnect 5500 series switch, and N series switches, the command uses privilege instead of level


console(config)#username Dell password PowerConnect privilege 15

Note: You may make multiple users on the switch, as well as different levels/privilege level of access. Privilege level could be 0,1 or 15 meaning 0 is no access, 1 in read only, and 15 is read and write.







Article ID: HOW10354

Last Date Modified: 09/14/2019 12:39 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.