Dell EMC PowerSwitch N-Series

Dell EMC PowerSwitch N-Series





Overview

Dell EMC N-series is a family of energy-efficient, cost-effective 1GbE, 2.5GbE, 5GbE and 10GbE Open Networking switches designed for modernizing and scaling campus networks. Customer’s choice includes Dell EMC enterprise-class layer 2, layer 3 feature set with OS 6 or select third-party network operating systems. Delivering a great choice of number of PoE and number of ports, they are ideal for powering wireless access points, voice over IP phones, surveillance cameras, building automation and Internet of Things.
Dell EMC Networking OS10 Info Hub
Dell EMC Networking Hardware Platforms OS9 Info Hub
How to enable HTTPS/SSH and disable HTTP/Telnet for switch management on Dell EMC Networking N-Series Switches
How to stack Dell EMC Networking N2000 or N3000 switches
Types of console cables used for Dell EMC Networking N-Series and Force10 switches
How to set up Link Dependency on a Dell EMC Networking Networking N-Series Switch
How to configure a LACP Port-Channel on a DNOS 6 Switch
How to configure a static Port-Channel on an Dell EMC Networking N-Series Switch
How to configure Radius or TACACS authentication for switch management on Dell EMC Networking N-Series switches
How to automatically synchronize firmware when adding a Dell EMC Networking N-Series switch to a Stack
Updating firmware using OpenManage Switch Administrator web interface on the N2000, N3000, and N4000 series switches
How to set up management access for Dell EMC Networking Networking N2000, N3000 and N4000 series switches
How to manage Rapid Spanning Tree (RSTP) using Command Line on Dell EMC Networking N-Series switches
How to configure MAC based port security on Dell N2000, N3000, and N4000 series switches
How to create Link Aggregation Groups (LAGs) on Dell EMC Networking N-Series switches
How to set a username and password for Web and Telnet access on Dell EMC Networking N-Series switches
How to configure Simple Network Time Protocol (SNTP) on Dell EMC Networking N-Series
Performing interface range commands on 7000, 8000, 8100, M6220, M6348, M8024-K N2000, N3000 and N4000 series switches
How to save and back up your configuration on Dell EMC Networking Force10 and N-Series switches via CLI
How to use General Switchport Mode on Dell EMC Networking N-Series switches

Article ID: SLN316270

Last Date Modified: 05/02/2019 03:38 PM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.