E-Port II - Visual Guide to your Dock

E-Port II - Visual Guide to your Dock

Note: For a more detailed description about each location, please go to the system manuals at www.dell.com/Manuals

The following article is a visual guide to the external ports and features of the E-Port II Dock.

Table of Contents:

  1. Front View
  2. Rear View
  3. Left View
  4. Right View
  5. AC Adapter View
  6. Connecting a system to this Dock
  7. Disconnecting a system from this Dock

Front View

Front View

(Fig.1 Front View of Dock.)

1 Battery Bar Adjuster 2 Alignment Mark
3 Power Button 4 Docking LED
5 Eject Button 6 Docking Connector

Back to Top

Rear View

Rear View

(Fig.2 Rear View of Dock.)

1 Network Connector 2 Battery Bar Adjuster
3 E-Monitor Stand Connector 4 USB 2.0 or eSATA Connector
5 USB 3.0 Connector x2 6 VGA connector
7 DVI Connector 8 DisplayPort Connector
9 AC Adapter

Back to Top

Left View

Left View

(Fig.3 Left Hand Side View of Dock.)

1 USB 2.0 Connector x3 2 Headphone Connector
3 Microphone Connector

Back to Top

Right View

Right View

(Fig.4 Right Hand Side View of Dock.)

1 Eject Button 2 Security Cable Slot
3 Lock / Unlock Switch

Back to Top

AC Adapter View

130W Adapter

(Fig.5 130W AC Adapter.)

Type 130W Series Description
Input Voltage 100 VAC to 240 VAC
Output Power 130 W
Output Voltage 19.5 VDC

240W Adapter

(Fig.6 240W AC Adapter.)

Type 240W Series (seen as 210W on Dock) Description
Input Voltage 100 VAC to 240 VAC
Output Power 240 W
Output Voltage 19.5 VDC

Back to Top

Connecting a System to this Dock

Dock 1

(Fig.7 Docking Step 1.)

  1. This dock can work off of the Notebooks Battery or you can connect an AC adapter.

  2. Have the dock in a location with enough space to support the system once it's docked.

  3. If the system has a battery that extends behind the machine, then use the slide at the rear of the dock to adjust the sliding block flush with the battery.

Dock 2

(Fig.8 Docking Step 2.)

  1. Push the locking switch at the right hand side of the dock towards the rear of the dock to unlock it. DO NOT try and dock a system with this switch locked.

Dock 3

(Fig.9 Docking Step 3.)

  1. Line up the alignment marks on the dock and the system and push firmly down to seat the system on the docking connector. (You should hear a click as it seats in place.)

Dock 4

(Fig.10 Docking Step 4.)

  1. You can dock the system while it is turned on, however if you docked it whilst it was off - you can turn the system on by pressing the Power Button on either the system or the Dock.

  2. If it's doesn't boot correctly, undock the system and reseat it.

Back to Top

Disconnecting a System from this Dock

  1. Push the lock switch towards the rear of the dock to unlock it.

  2. Press the Eject button on the dock to undock it. Lift the system up and away from the dock.


(Fig.11 Un-Docking.)

Back to Top

Article ID: SLN285009

Last Date Modified: 09/06/2018 05:01 AM

Rate this article

Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.