SLES 10 iSCSI timeout after load balancing request when using the native open-iscsi
SLES 10 iSCSI timeout after load balancing request when using the native open-iscsi
This article provides information on what to do if a SUSE Linux Enterprise Server 10 using native open-iSCSI time outs after an iSCSI load balancing request.
Modify the /etc/iscsi/iscsid.conf
To improve this situation, there are two modifications that can be made to the /etc/iscsi/iscsid.conf.
If your discovery is password protected, provide the authentication information to iscsid by adding your password information for the discovery to the end of /etc/iscsid.conf file
discovery.sendtargets.auth.authmethod = CHAP
discovery.sendtargets.auth.username = <username>
discovery.sendtargets.auth.password = <password>
Then add the following 2 new entries to give a little wiggle room with connection timeouts on load balancing activities.
node.conn[0].timeo.noop_out_interval = 10
node.conn[0].timeo.noop_out_timeout = 30
Article ID: SLN111190
Last Date Modified: 12/22/2014 05:11 AM
Rate this article
Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.
Thank you for your feedback.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\