Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section.
Turn off the system, including any attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If installed, remove the front bezel.
If applicable, remove the system from the rack.
Lay the system on its side.
Remove the system cover.
Remove the cooling shroud.
Locate the Internal Dual SD Module (IDSDM) on the system board.
If installed, remove the SD card(s).
Removing the internal dual SD module:
Hold the pull tab and pull the IDSDM out of the system.
Installing the internal dual SD module:
Locate the Internal Dual SD Module (IDSDM) connector on the system board.
Align the IDSDM with the IDSDM connector on the system board.
Push the IDSDM until it is firmly seated on the system board.
Install the SD card(s).
NOTE: Temporarily label each SD card with its corresponding slot before removal. Replace the SD card(s) into the same slots.
Install the cooling shroud.
Follow the procedure listed in the After working inside your system section:
Install the system cover.
Place the system upright on a flat, stable surface.
If applicable, install the system into the rack.
If removed, install the front bezel.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the system, including any attached peripherals.