CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
Follow the safety guidelines listed in safety instructions section.
Before working inside your system
Turn off the blade by using the Chassis Management Controller (CMC).
Remove the blade from the enclosure.
Install the I/O connector cover.
Remove the system cover.
Keep the Phillips #2 screwdriver ready.
If installed, remove the internal USB key.
If installed, remove the SD card(s).
Removing the optional IDSDM card:
Remove the two screws securing the IDSDM card to the system board.
Remove the SD card slot bracket.
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
Lift the card up and away from the system.
Installing the optional IDSDM card:
Align the following:
The slot on the card edge with the projection tabs on the mezzanine card support.
The two screw holes on the IDSDM card with the standoffs on the system board.
The hole on the SD card slot bracket with the screw hole on the IDSDM card.
Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
If applicable, install the SD card(s) and the internal USB key.
After working inside your system:
Install the system cover.
Install the blade in the enclosure.
Turn on the blade.
