Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the air shroud.
If installed, remove the risers.
Removing the mini PERC card:
Using a Phillips #2 screwdriver, loosen the screws that secure the cable to the mini PERC card.
Holding the tab, lift the cable to disconnect from the mini PERC card.
Slide out the mini PERC card to disengage from the card holder on the system board.
Lift the mini PERC card out of the system.
Installing the mini PERC card:
Angle the mini PERC card to engage with the mini PERC card holder on the system board.
Lower the mini PERC card into place until the mini PERC card is firmly seated on the card holder.
Align the screws on the cable with the screw holes on the mini PERC card.
Using a Phillips #2 screwdriver, secure the cable to the mini PERC card with the screws.
If removed, install the expansion card risers.
Install the air shroud.
Follow the procedure listed in the After working inside your system.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
