Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system:
Turn off the system, including all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the air shroud.
Remove the expansion card riser 1.
Removing network daughter card:
Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
Hold the NDC by the edges, and lift to disengage it from the connector on the system board.
Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back of the system.
Installing network daughter card:
Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
Align the captive screws on the card with the screw holes on the system board.
Press the touch points on the card until the card connector is firmly seated on the system board connector.
Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
Install the expansion card riser 1 or the rear drive cage, depending on the configuration of your system.
Install the air shroud.
Follow the procedure listed in After working inside your system:
Install the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.