How to replace SSD Cage for PowerEdge FM120

This video will demonstrate the replacement procedure of an SSD Cage for the PowerEdge FM120.

Removing the SSD cage assembly:
Turn off the nodes using the operating system commands, or the iDRAC, or the CMC.
The sled is powered off when all the nodes are turned off.
Remove the sled from the enclosure.
Remove the SSDs.
Remove the SATA and power cables from the SSD backplane of the cage assembly.
Loosen the spring-loaded screw that secures the SSD cage assembly to the sled chassis.
Slide the SSD cage assembly out of the sled.

Installing the SSD cage assembly:
Align the SSD cage assembly with the slot in the sled.
Slide the SSD cage assembly into the chassis until it is firmly seated and the spring-loaded screw on the cage aligns with the screw hole on the chassis.
Tighten the spring-loaded screw to secure the SSD cage assembly to the chassis.
Connect the SATA and power cables to the SSD backplane connectors.
Install the SSDs.
Install the sled in the enclosure.
Turn on the sled.