Prerequisites
Follow the safety guidelines listed in Safety instructions.
Turn off the system, including all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
Removing the air shroud:
Hold the air shroud at both ends and lift it away from the system.
NOTE The system with 2 x 3.5-inch rear drive has a different air shroud. However, the procedure to remove the air shroud is identical.
Removing the PERC card from the internal PERC riser:
Using a Phillips #2 screwdriver, remove the screw that secures the PERC card to the internal PERC riser.
Pull the PERC card out of the connector on the internal PERC riser.
Removing the left control panel:
Disconnect the control panel cable from the system board connector.
NOTE Ensure that you note the routing of the cables as you remove them from the system board. You must route the cables properly when you replace them to prevent the cables from being pinched or crimped.
Using a Phillips #1 screwdriver, remove the screws that secure the left control panel assembly to the system.
Holding by the sides, remove the left control panel assembly away from the system.
Installing the left control panel:
Route the control panel cable through the side wall of the system.
Align the left control panel assembly with the control panel slot on the system and place the assembly in the slot on the system.
Connect the control panel cable to the system board connector.
Using Phillips #1 screwdriver, tighten the screws to secure the left control panel assembly to the system.
Installing the air shroud:
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
NOTE The procedure to install the air shroud for 2 x 3.5-inch rear drive system is identical.
Installing PERC card into the internal PERC riser:
Insert the PERC card into the internal PERC riser and push the card in.
Using a Phillips #2 screwdriver, replace the screw to secure the PERC card on the internal PERC riser.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
