Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
NOTE:The procedure to remove the intrusion switch module is the same for Rear Accessed and Front Accessed configurations.
Removing the intrusion switch module:
Disconnect and remove the intrusion switch cable from the connector on the power interposer board (PIB).
NOTE:Observe the routing of the cable as you remove it from the system.
Using the Phillips 1 screwdriver, remove the screw securing the intrusion switch module.
Lift the intrusion switch module out of the system.
Installing the intrusion switch module:
Align and insert the intrusion switch module until it is firmly seated in the slot on the system.
Using the Phillips 1 screwdriver, tighten the screw securing the intrusion switch module.
Connect the intrusion switch cable to the connector on the power interposer board (PIB).
Reconnect all the cables to the power interposer board (PIB).
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
