Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the support bar.
Remove the air shroud top cover.
Remove the cooling fan cage assembly.
Remove the air shroud.
Remove the expansion card risers or remove the full length expansion card riser.
NOTE: See cable routing section for more information.
Remove the riser air shroud.
If required, remove the processor expansion module (PEM).
NOTE:PEM along with DLC module can be removed by disconnecting the tubes from the tube holder on the system board or from the slot on the riser 2 and from the rear wall. See remove the DLC module on the PEM topic to disconnect the DLC tubes.
Removing the OCP card:
Open the blue latch to disengage the OCP card.
Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
Slide the OCP card out of the slot on the system.
If the OCP card is not going to be replaced, install a filler bracket .
NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
Installing the OCP card:
If installed, remove the filler bracket.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
Open the blue latch on the system board.
Slide the OCP card into the slot in the system.
Push until the OCP card is connected to the connector on the system board.
Close the blue latch to lock the OCP card to the system.
If removed, install the processor expansion module (PEM).
NOTE:PEM along with DLC module can be installed by connecting the tubes into the tube holder on the system board or into the slot on the riser 2 and into the rear wall. See install the DLC module on the PEM topic to connect the DLC tubes.
Install the riser air shroud.
Install the expansion card risers or Install the full length expansion card riser.
Install the air shroud
Install the cooling fan cage assembly.
Install the air shroud top cover.
Install the support bar.
Follow the procedure listed in After working inside your system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system."
