In this video, we'll show you how to replace the 3.5 inch hard drive in your Alienware Aurora ACT 1250. Before you begin, create a recovery drive and backup all data. Ensure that your computer is turned off and all connected devices are unplugged. Remember to use ESD protection when you are working inside the computer to ensure your personal safety. For more information on ESD protection, refer to the Alienware Aurora ACT1250 Owner's Manual.
To begin, loosen the captive screw that secures the left side cover release latch to the chassis, then pull left side cover release latch to release and lift the left side cover away from the chassis. Lay a computer on its right side.
To remove the hard drive, disconnect the power and data cables from the hard drive. Press the release tabs on the hard drive carrier and slide the hard drive assembly out of the hard drive cage. Pry the carrier to release the tabs on the carrier from the slots on the hard drive, then lift the drive out of the carrier.
To install a hard drive, align it with the pins on the hard drive carrier. Using the tabs on the opposite side, flex open the carrier to insert the pins on the other side. Slide the hard drive assembly into the hard drive cage until it snaps into place. Then connect the data and power cables to the hard drive.
To install the left side cover, place the computer upright. Locate the tabs on the cover and slots on the chassis. Rotate the cover towards the chassis until it clicks into place. Finally tighten the captive screw that secures the left side cover release latch to the chassis. For more information about the Alienware Aurora ACT1250 visit Dell.com/Support.
