Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Removing the BOSS-N1 module:
Pull and lift the BOSS-N1 card carrier retention latch lock to open.
Slide the BOSS-N1 card carrier out.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card carrier.
Slide the M.2 SSD out from the BOSS-N1 card carrier.
Disconnect the BOSS-N1 power and signal cable from the system board.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screws that secures the BOSS-N1 module .
Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Pull the blue tag to remove the BOSS-N1 signal cable from the BOSS-N1 module.
Remove the BOSS-N1 power cable from the BOSS-N1 module.
CAUTION: To avoid damaging the power cable connector, press the latch on the BOSS-N1 power cable before disconnecting.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing the BOSS-N1 module:
Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Insert the BOSS-N1 module and push the module horizontally towards the rear of the system until firmly seated.
Using the Phillips #1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screws.
Connect the BOSS-N1 power and signal cable to the connectors on the system board.
Align the M.2 SSD at an angle with the BOSS-N1 card carrier.
Insert the M.2 SSD until it is firmly seated in the BOSS-N1 card carrier.
Using the Phillips #1 screwdriver, secure the M.2 SSD on the BOSS-N1 card carrier with the M3 x 0.5 x 4.5 mm screw.
Slide the BOSS-N1 card carrier into the BOSS-N1 module slot.
Close the BOSS-N1 card carrier release latch to lock the carrier in place.
Follow the procedure listed in After working inside your system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
