How to Replace BOSS Module for PowerEdge XE9680

This video will demonstrate the replacement procedure of the BOSS module for the PowerEdge XE9680.

Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.

Removing the BOSS Module:
Disconnect the intrusion cable from rear I/O board.
Using both hands, pull up the plunger and hold the BOSS cage.
Slide the BOSS cage toward the rear of the system to unlock from key slot.
Lift the BOSS cage from the system.

Installing the BOSS Module:
Align and place the BOSS cage on the system.
Slide the BOSS cage toward the front of the system until it clicks into place to lock from key slot.
NOTE:Plunger auto locks into place.
Connect the intrusion cable to the rear I/O board.

Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.