Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the cooling fan cage assembly.
Remove the air shroud.
Observe and disconnect the cables from the connectors on the power distribution board.
Remove the PSU cage.
NOTE: Ensure that you note the routing of the cable as you remove it from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Removing the intrusion switch module:
Disconnect the intrusion switch cable from the connector on the rear I/O board.
Using a Phillips 1 screwdriver, loosen the screw on the intrusion switch module.
Slide the intrusion switch module out of the slot on the system.
Installing the intrusion switch module:
Align and slide the intrusion switch module into the slot in the system until firmly seated.
Using a Phillips 1 screwdriver, tighten the screw on the intrusion switch module.
Connect the intrusion switch cable to the connector on the rear I/O board.
Replace the PSU cage.
Observe and connect the cables to the connectors on the power distribution board.
Replace the air shroud
Replace the cooling fan cage assembly.
Replace the front top cover.
Follow the procedure listed in After working inside your system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
