Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the front top cover.
Remove the cooling fan cage assembly.
Remove the air shroud .
Remove the drives.
Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
Slide out the drive cage.
If required, remove the front PERC module.
Remove the PSB top cover.
Observe and disconnect the cables connected to PSB module from system board.
Removing the PCIe Switch Board module:
Push the PSB handle toward rear of the chassis, to disengage it from the PBB slot.
Lift the PSB module from the chassis.
Installing the PCIe Switch Board module:
Align the PSB module with the connector on the PBB.
Insert the PSB module firmly into the PBB until seated.
Push the PSB handle toward the front of the chassis, to engage it with PBB slot.
Connect the cables to PSB module from system board.
Replace the PSB top cover.
If required, install the front PERC module.
Slide in the drive cage.
Connect the drive backplane cables to the connectors on the system board and backplane.
Replace the drives.
Replace the air shroud
Replace the cooling fan cage assembly.
Replace the front top cover.
Follow the procedure listed in After working inside your system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
