Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the riser 1A and 4A for Intel GPU configurations or Remove the riser 1B and 4B for NVIDIA GPU configurations.
Removing the VSB assembly and VSB:
Using the Phillips 2 screwdriver, remove the screws to disengage the VSB cable from the VSB board connected to the system board.
Disconnect the signal cable from the VSB.
Lift the plunger and slide the VSB tray to rear of the system.
Disengage the VSB tray from the system board and lift it out of the system.
NOTE: The procedure to remove the left and right VSB is similar.
For Intel GPU configurations, remove the storage tray, and then disconnect the VSB cables from the PDB of the bottom layer and disconnect the VSB cables from the system board.
For NVIDIA GPU configurations, disconnect the VSB cables from the system board. Disconnect the VSB cables from the PDB2 of the storage tray. Remove the storage tray. Disconnect the power cable from the PBD of the bottom layer connected on to the PDB2 on the storage tray. Remove the system board tray. Disconnect the VSB cables from the PDB on the bottom layer.
Remove all the screws and lift the VSB from the VSB tray.
Installing the VSB and VSB assembly:
Align the VSB on the tray and using the Phillips 2 screwdriver, tighten the screws to secure the VSB on to the VSB tray.
Align the VSB on the system board tray. Lift the plunger, align the VSB tray to the system board and slide it toward the front of the system.
Align the power cable to the VSB and secure the cables with the screws. Using the Phillips 2 screwdriver, tighten the screws with torque force 10 in-lbf to secure the VSB on to the VSB tray.
NOTE: The procedure to install the left and right VSBs are same.
For Intel GPU configurations, reconnect the VSB cables on the PDB of the bottom layer. Install the system board tray, and then install the storage tray into the chassis. Reconnect the VSB cables on the system board.
For NVIDIA GPU configurations, reconnect the VSB cables on the PDB of the bottom layer. Install the system board tray, and then install the storage tray into the chassis. Reconnect the VSB cables on the PBD2 of the storage tray and on the system board.
Reconnect the signal cable on to the VSB.
Install the riser 1A and 4A for Intel GPU configurations or install the riser 1B and 4B for NVIDIA GPU configurations.
Follow the procedure listed in After working inside your system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
