How to replace Internal USB for PowerEdge MX740c and MX840c

This video will demonstrate the replacement procedure of an Internal USB for PowerEdge MX740c and MX840c.

Prerequisites
CAUTION: To avoid interference with other components in the server module, the maximum permissible dimensions of the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your sled.

Power off the sled.
Remove the sled from the enclosure.
If applicable install the I/O connector cover.
CAUTION To prevent damage to the I/O connectors on the system, ensure that you cover the connectors when you remove the system from the enclosure.
Remove the system cover.

Replacing the optional internal USB memory key:
Locate the USB port or USB memory key on the system board.
If installed, remove the USB memory key from the USB port.
Place the replacement USB memory key into the USB port.

While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Follow the procedure listed in After working inside your sled:
Install the system cover.
If installed, remove the I/O connector cover on the system.
CAUTION: To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
Install the sled in the enclosure.
Power on the sled.
NOTE: Ability to power on the sled requires iDRAC to fully initialize first.