How to Replace the VGA Port Optional Module on Dell Pro Micro QCM1250

This video will demonstrate the replacement procedure of a VGA Port Optional Module for the Dell Pro Micro QCM1250.

Be sure to read and follow the safety guidelines to protect your computer from potential damage and ensure your personal safety. For more information about safety guidelines, see the owner's manual at Dell.com/Support. Before you begin, turn off the computer and disconnect all the attached peripherals.

To remove the VGA port. Loosen the screws securing the side cover. And slide the cover off the system to remove it. Identify the VGA module. Optional input output module. Loosen the two screws. Disconnect the VGA module from the connector. Lift the VGA module out of the system.

To reinstall the VGA port. Connect the VGA module to the connector. And secure it with the two screws. Place the side cover on the chassis by aligning the tabs on the side cover with the slots on the chassis. Slide the side cover towards the rear of the computer. Tighten the screw. For more information about your Dell system, visit Dell.com/Support.