How to replace the PS2 port module on Dell Pro Micro Plus QBM1250/Dell Pro Micro QCM1250/QCM1255

This tutorial provides step-by-step instructions on how to remove and install the PS2 port module on your Dell Pro Micro Plus QBM1250/Dell Pro Micro QCM1250/QCM1255. By following the steps in this video, you can also remove and install the serial port module on your computer. Before you begin, power off the computer, and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the system.

In this video, we show how to replace the PS2 port module on the Dell Pro Micro Plus QBM1250, the Dell Pro Micro QCM1250, or the Dell Pro Micro QCM1255. Before you begin, turn off the computer and disconnect all attached peripherals. Ensure that you always use ESD protection when working inside the computer.

To begin, place the computer on its side with the side cover facing up. Now, loosen the rear thumb screw that secures the side cover and slide it off the chassis. inside the chassis, locate the PS2 port module. Disconnect the module cable from its connector. Loosen the two captive screws that secure the module in its place.

To remove it, lift the module from the rear, tilt it downward and slide it out of the chassis. If you are installing a PS2 module for the first time, you will need to remove the port cover. Push against the port cover as shown until it comes off.

Now, to install the PS2 port module, slide it into the slot on the back panel. Then tighten the two screws to secure the module. Connect the cable to its connector. Now, to install the side cover, align the tabs on the side cover with the slots on the chassis. Slide the cover back into place and tighten the thumb screw. For more information or support, visit: Dell.com/Support.