This tutorial provides step-by-step instructions on how to remove and install the retractable-camera module on Dell 24 All-in-One EC24250/Dell 27 All-in-One EC27250. Before you begin, power off your computer and disconnect all attached peripherals. Always wear ESD wrist strap while working inside the computer to prevent damage due to electrostatic discharge. If you need more information about Dell 24 All-in-One EC24250/Dell 27 All-in-One EC27250, visit: Dell.com/Support.
In this video, we'll demonstrate how to replace the retractable camera module, on a Dell 24 All-in-One EC24250 or Dell 27 All-in-One EC27250 Before you begin. Turn off the computer and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the computer.
To begin, place your computer display down on a flat surface with the stand over the end. Now locate the tab underneath each stand. Then push a scribe into the tab and release the stand from the display assembly base. Similarly, remove the other stand. Next, place your palm on the middle of the back cover, then pry the back cover starting from the top to release it from the display assembly base.
Then lift it away from the base. Remove the screws to secure the I o cover to the display assembly base. Pry open the corners of the IO cover. Then lift it away from the base. Next, remove the screws. The secure the system board shield to the display assembly base.
Then lift away from the base. Disconnect the camera cable from its connector on the system board, then peel the tape to secures it to the display assembly base. Now remove the screws to secure the retractable camera assembly to the display assembly base, Then slide it out to remove it.
To install the retractable camera assembly, slide and place the retractable camera assembly on the display assembly base. Then replace the screws to secure the camera to the base. Next, connect the camera cable to the connector on the system board. then adhere the tape that secures a camera cable to the display assembly base, Align the screw holes on the system board shield, with the screw holes on the display assembly base. Then replace the screws to secure the shield to the base.
Align the screw holes on the IO cover, with the screw holes on the base. then snap the IO cover back into place. Replace the screws, that secure the IO cover to the base, Next, align the slots on the back cover, with the slots on the computer. Then press along the sides to snap the back cover into place. Now insert the stand into the slot on the back of the system until it snaps into place. Similarly, install the other stand. For more information about the Dell 24 All-in-One EC24250 or Dell 27 All-in-One EC27250, visit: Dell.com/Support.
