Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the air shroud.
Removing the OCP card:
Slide the OCP air shroud toward the front of the system and lift the OCP air shroud out of the system.
Open the blue latch to disengage the OCP card.
Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
Slide the OCP card out of the slot on the system.
If the OCP card is not going to be replaced, install the OCP card blank.
Installing the OCP card:
If installed, remove the OCP card blank.
Open the blue latch on the system board.
Slide the OCP card into the slot in the system.
Push until the OCP card is connected to the connector on the system board.
Close the blue latch to lock the OCP card to the system.
Align the OCP air shroud to the guide pins on the chassis and lower the OCP air shroud.
Install the air shroud.
Follow the procedure listed in After working inside the system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.