Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Removing the front bezel:
Unlock the bezel.
Press the release button, and disengage the left end of the bezel.
Unhook the right end, and remove the bezel.
Removing the air shroud:
Hold the air shroud at both ends and lift the air shroud out of the system.
Removing the right control panel:
Disconnect the control panel cable and the VGA cable from the system board connector and remove the cable from cable clip.
NOTE Observe the routing of the cable as you remove it from the system.
Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
Hold the right control panel assembly and remove the control panel along with the cable from the system.
NOTE The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing the right control panel:
Route the control panel cable through the latch, side wall of the system, and then slide the cable into the clip.
NOTE Route the cable properly to prevent the cable from being pinched or crimped.
Align and insert the right control panel in the slot on the system.
Connect the right control panel cable to the connector on the system board.
Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing the air shroud:
Align the slot on the air shroud with the standoff on the chassis.
Lower the air shroud into the system until it is firmly seated.
Installing the front bezel:
Align and insert the tabs on the bezel into the slots on the system.
Press the bezel until the release button clicks in place.
Lock the bezel.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.