CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
Follow the safety guidelines listed in safety instructions section.
Keep the Phillips #2 screwdriver ready.
Follow the procedure listed in the Before working inside your system section.
Remove the PCIe mezzanine card. See the Removing the PCIe mezzanine card section.
Removing the Network Daughter Card:
Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
Lift the card from the system board.
slot on the NDC
screw (2)
NDC
standoff (2)
connector on the system board
tab projections
Installing the Network Daughter Card:
Align the following:
The slots on the card edge with the projection tabs on the plastic bracket covering the PCIe mezzanine card slots.
Screw holes on the card with the standoffs on the system board.
CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
Lower the card into place until the card connector fits into the corresponding connector on the system board.
Secure the card with the two screws.
slot on the NDC
screw (2)
NDC
standoff (2)
connector on the system board
tab projections
Install the PCIe mezzanine card. See the Installing a PCIe Mezzanine card section.
Follow the procedure listed in the After working inside your system section.
