Prerequisites
WARNING A new battery can explode if it is installed incorrectly. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. For more information, see the Safety instructions documentation that is shipped with your system.
Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the expansion card riser.
If applicable, disconnect the power or data cables from the expansion card(s).
To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION: To prevent damage to the battery connector, you must firmly support the connector while removing or installing a battery.
To install a new system battery:
a. Slide the battery with the positive side facing up under the securing tabs.
b. Press the battery into the connector until it snaps into place.
If applicable, Install the expansion card riser and connect the cables to the expansion card(s).
Follow the procedure listed in the After working inside your system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect.
