How to replace 3.5 HDD for Dell Storage ME4084 and ME484

This video will demonstrate the replacement procedure of a 3.5" HDD for the Dell Storage ME4084 and ME484.

Removing HDD:
Press the latch on the drive module carrier to open the handle.
Gently move the drive carrier module approximately 25 mm (1 in.), and then wait 30 seconds for the drive to spin down.
Remove the drive carrier module from the drive slot.

Installing HDD:
Press the latch on the drive module carrier to open the handle.
Insert the drive carrier module into the enclosure.
Gently slide the drive carrier module into the enclosure until it stops moving.
Push the drive carrier module further into the enclosure until the latch handle starts to engage.
Continue to push firmly until the latch handle fully engages. You should hear a click as the latch handle engages and holds the handle closed.

Use the PowerVault Manager or CLI to verify the following:
Health of the new disk drive is OK
Green Disk Activity LED is on/blinking
Ops panel states show no amber module faults