How to Replace a BOSS N1 M.2 Carrier on a PowerEdge R260

This video demonstrates the removal and installation process for a BOSS N1 M.2 Module on a PowerEdge R260.

In this video, we show how to replace a BOSS-N1 M.2 carrier on a PowerEdge R260. Before removing the BOSS-N1 M.2 carrier, read through and follow safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the PowerEdge R260 Service Manual at Dell.com/Support.

To remove the BOSS-N1 M.2 carrier, lift the retention latch to unlock it. Using the retention latch, pull the module out of the system. Use a screwdriver to remove the screw securing the M.2 NVMe SSD to the module. Lift the M.2 at an angle and remove.

To install a BOSS M.2 NVMe SSD, align the M.2 at an angle and insert it into the module. Use a screwdriver to tighten the screw to secure it in place. Slide the BOSS-N1 M.2 carrier into the slot, then close the latch to secure it in place. For more information or support about the PowerEdge R260, visit: Dell.com/Support.