Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Removing the expansion card risers:
For Riser 1, press the blue tab and holding the edges lift the expansion card riser from the riser connector on the system board.
For Riser 2 and liquid cooling Riser 2, press the blue button on the riser, and holding the touch points lift the expansion card riser from the riser connector on the system board.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
For Riser 3 and liquid cooling Riser 3, press the blue button on the riser, and lift the expansion card riser from the riser connector on the system board.
For Riser 4, press the blue tab on the riser, and holding the touch point lift the expansion card riser from the riser connector on the system board.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped
Removing the intrusion switch module:
Disconnect the intrusion switch cable from the connector on the rear I/O board.
Using a Phillips #2 screwdriver, loosen the screw on the intrusion switch module.
Slide the intrusion switch module out of the slot on the system.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing the intrusion switch module:
Align the guides on the intrusion switch module with the standoffs on the system.
Slide the intrusion switch module into the slot in the system until firmly seated.
Using a Phillips #2 screwdriver, tighten the screw on the intrusion switch module.
Connect the intrusion switch cable to the connector on the rear I/O board.
Installing the expansion card risers:
Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
