Prerequisites
Follow the safety guidelines listed in safety instructions.
Follow the procedure listed in the Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
If you are replacing the IDSDM module, remove the MicroSD cards.
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into the corresponding slots.
Removing the IDSDM module:
Holding the blue pull tab, lift the IDSDM module out of the system.
Installing the IDSDM module:
Locate the IDSDM connector on the system board.
To locate IDSDM module, see the System board jumpers and connectors section.
Align IDSDM module with the connector on the system board.
Press the IDSDM module until it is firmly seated in the connector on the system board.
Install the MicroSD cards.
Follow the procedure listed in After working inside the system.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals, and connect the system to the electrical outlet, and then power on the system.
