How to Replace GPU Shroud for PowerEdge XE8545

This video will demonstrate the replacement procedure of a GPU Shroud for the PowerEdge XE8545.

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.

Remove the middle top cover.
Disconnect all cables that are connected to the drive backplane.

Removing the GPU air shroud:
Press the release latches of the GPU air shroud, and slide the GPU air shroud towards to rear of the system.
Tilt the front of the GPU air shroud and lift it out of the system.

Installing the GPU air shroud:
Hold the GPU air shroud with the front tilted up at an angle.
Lower the GPU air shroud into the system and slide the GPU air shroud to the front of the system, until it clicks firmly into place.

Connect the cables to the drive backplane.
Install the middle top cover.

Follow the procedure listed in After working inside your system.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.