Prerequisites
Follow the safety guidelines listed in Safety instructions.
Turn off the system, including all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Removing the system cover:
Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.
Hold the cover on both sides, and lift the cover away from the system.
Disconnect all the cables from the drive backplane.
CAUTION:The drive tray is hot to touch for some time after the system has been powered down. Allow time for the drive tray to cool before handling it.
Removing mid drive tray:
Lift the drive tray handles 90 degrees upward.
Hold the drive tray handles, and lift the drive tray out of the system.
Installing the mid drive tray:
Lift the drive tray handles to 90 degrees upward.
Hold the drive tray handles, and align the slots on the drive tray with the guide pins on the system.
Lower the drive tray into the system.
Lower the drive tray handles to lock the drive tray in place.
Installing the system cover:
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the guide slots on the system and the system cover latch locks into place.
Using a 1/4 inch flat head or Phillips #2 screwdriver, rotate the latch release lock clockwise to the locked position.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
