Prerequisites
Follow the safety guidelines listed in Safety instructions.
Disconnect the power cable from the power source and from the PSU you intend to remove, and then remove the cable from the strap on the PSU handle.
CAUTION: The power supply is only hot-swappable if you have a redundant system with two power supplies installed
Removing a power supply unit:
Press and hold the release latch.
Slide the PSU out of the system using the PSU handle.
Installing a power supply unit:
Slide the PSU into the system until the PSU is fully seated and the release latch snaps into place.
Connect the power cable to the PSU, and plug the cable into a power outlet.
CAUTION: Secure the power cable to the PSU with the strap provided on the PSU handle.
NOTE: When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the PSU and determine its status. The PSU redundancy may not occur until discovery is complete. Wait until the new PSU is discovered and enabled before you remove the other PSU. The PSU status indicator turns green to signify that the PSU is functioning properly.
