Prerequisites
Follow the safety guidelines listed in Safety instructions.
Turn off the system, including all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Removing the system cover:
Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.
Hold the cover on both sides, and lift the cover away from the system.
Removing the air shroud:
Hold the air shroud at both ends and lift it away from the system.
Removing the cooling fan assembly:
Lift the release levers to unlock the cooling fan assembly from the system.
Hold the release levers, and lift the cooling fan assembly away from the system.
Removing the right control panel:
Disconnect the VGA cable from the system board.
Pull the cable latch and disconnect the control panel cable from the system board connector.
Using Phillips #1 screwdriver, remove the screws that secure the control panel and cable tube to the system.
Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
Installing the right control panel:
Route the control panel cable and VGA cable through the side wall of the system.
Align the control panel with the control panel slot on the system and attach the control panel to the system.
Connect the VGA cable to the system board.
Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
Using a Phillips #1 screwdriver, install the screw that secures the control panel and cable tube to the system.
Installing the cooling fan assembly:
Align the guide rails on the cooling fan assembly with the standoffs on the system.
Lower the cooling fan assembly into the system until the cooling fan connectors engage with the connectors on the system board.
Press the release levers to lock the cooling fan assembly into the system.
Installing the air shroud:
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
Installing the system cover:
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the guide slots on the system and the system cover latch locks into place.
Using a 1/4 inch flat head or Phillips #2 screwdriver, rotate the latch release lock clockwise to the locked position.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
