How to replace riser 1 on a PowerEdge R7715/R5715

This video demonstrates the replacement procedure for riser 1. It is demonstrated on a PowerEdge R7715 and the process is applicable for PowerEdge R5715.

In this video we show how to replace riser one in a PowerEdge R7715. Before working inside your system, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the Service Manual at: Dell.com/Support.

To remove riser one with the cover, air shroud and fan cage assembly removed, loosen the two captive screws on the rear of the system. Then disconnect the cables from the HPM and unwrap them. And then press the blue release latch and lift up on the riser and remove.

To install a riser one, align and lower it into the system until fully seated. Then tighten the captive screws on the rear of the system. And then reroute and connect the cable to the HPM. And get the cable under that routing. For more information or assistance about the PowerEdge R7715, visit: Dell.com/Support.