Follow the safety guidelines listed in Safety Instructions.
Follow the procedure listed in Before working inside the sled.
Power off the sled.
Remove the sled from the enclosure.
If applicable install the I/O connector cover.
CAUTION: To prevent damage to the I/O connectors on the system, ensure that you cover the connectors when you remove the system from the enclosure.
Remove the:
a. cover
b. memory
c. expansion card(s)
d. heat sink
e. processor
Disconnect all the cables connected to the system board.
4. Remove the screws that secure the system board to the computer.
5. Slide the system board towards the front of the computer.
6. Carefully tilt the system board to 45–degrees, and then lift the system board out of the computer.
Installing the System Board
Align the system board to the port connectors on the rear of the chassis and place the system board in the chassis.
Tighten the screws securing the system board to the chassis.
Connect the cables to the system board.
4. Install the:
a. processor
b. heat sink
c. expansion card(s)
d. memory
e. cover
Follow the procedure listed in After working inside your sled.
If installed, remove the I/O connector cover on the system.
CAUTION: To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
Install the sled in the enclosure.
Power on the sled.
NOTE: Ability to power on the sled requires iDRAC to fully initialize first.
