How to replace the backplane on a PowerEdge XE7740

This video demonstrates the process of removing and installing the backplane on a PowerEdge XE7740.

In this video, we show how to replace the E3 drive backplane, in a PowerEdge XE7740. Before working inside your system, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the service manual at, Dell.com/Support. 

To remove the E3 drive backplane, First, disconnect the cables, remove the four screws on the board Using the Phillips 2 screwdriver, and lift it out of the tray.

To install the E3 drive backplane, place it on the tray, tighten the four screws by using a Phillips 2 screwdriver and reconnect the cables For more information or support about the PowerEdge XE7740, visit, Dell.com/Support.