In this video we show how to replace the HPM in a PowerEdge R7715. Before working inside your system, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the Service Manual at: Dell.com/Support.
To remove an HPM with the cover, air shroud, fan cage assembly, risers one, three, five, two, and four, as well as DC-SCM attic board, boss module, OCP, memory, heatsink and processor removed from the system, as well as the side wall brackets, disconnect any further cables that you have still connected. And unwrap them and get them out of the way. And then the intrusion switch as well.
Then lift up on the plungers. Slide the system towards the front of the system, the HPM to the front of the system, and then lift and remove.
To install an HPM, align and lower it into the system and slide it towards the rear of the system to lock it in place. Then reconnect any of the cables that you just disconnected and reroute them. Reconnect and route the intrusion switch. Reconnect the right control panel. Reroute these. For more information or assistance about the PowerEdge R7715, visit: Dell.com/Support.