How to replace the right control panel on a PowerEdge XE7740

This video demonstrates the process of removing and installing the right control panel on a PowerEdge XE7740.

In this video, we show how to replace the Right Control Panel, on a PowerEdge XE7740. Before working inside your system, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the service manual at, Dell.com/Support. 

To remove right control panel, disconnect the primary control panel cable from the connector in the HPM. and unroute the cable then, remove the screws that secures the right control panel to the system. Holding the right control panel, slide the right control panel, out of the system.

To install the right control panel, route the cable through the side of the chassis wall, then align and slide the right control panel into the system. tighten the screws that secures the right control panel. then, route the cable then connect the control panel cable to the HPM For more information or support about the PowerEdge XE7740, visit, Dell.com/Support.