How to Replace BOSS Module for PowerEdge R760

Dive into the removal and installation of the BOSS-N1 module in this comprehensive tutorial. From detaching the BOSS-N1 card carrier to securing the M.2 NVMe SSD, each step is carefully explained. Follow the guide for a seamless process, ensuring proper alignment and connection of cables for optimal functionality.

Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.

Removing the BOSS-N1 module:
Pull and lift the BOSS-N1 card carrier retention latch lock to open.
Slide the BOSS-N1 card carrier out.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1 card carrier.
Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
Disconnect the BOSS-N1 power and signal cable from the system board.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS-N1 module on Riser 1.
Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Pull the blue tag to remove the BOSS-N1 signal cable from the BOSS-N1 module.
Remove the BOSS-N1 power cable from the BOSS-N1 module.

Installing the BOSS-N1 module:
Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Align the BOSS-N1 module at an angle with the controller card module slot.
Insert the BOSS-N1 module and push the module horizontally towards the rear of the system until firmly seated.
Using the Phillips #1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screw.
Connect the BOSS-N1 power and signal cable to the connectors on the system board.
Align the M.2 NVMe SSD at an angle with the BOSS-N1 card carrier.
Insert the M.2 NVMe SSD until it is firmly seated in the BOSS-N1 card carrier.
Using the Phillips #1 screwdriver, secure the M.2 NVMe SSD on the BOSS-N1 card carrier with the M3 x 0.5 x 4.5 mm screw.
Slide the BOSS-N1 card carrier into the BOSS-N1 module slot.
Close the BOSS-N1 card carrier release latch to lock the carrier in place.

Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.