Dell EMC Networking OS6 How to stack N1500 series switches
Résumé: Information about stacking Dell EMC Networking N1500 series switches.
Cet article concerne
Cet article ne concerne pas
Cet article n’est associé à aucun produit spécifique.
Toutes les versions du produit ne sont pas identifiées dans cet article.
Instructions
1. Update each switch to the latest firmware using the instruction included in the zip file. The firmware may be found on dell.com/support
2. Configure ports to be used for stacking. It is recommended to use at least two ports on each switch to allow a ring topology connection.
3. Input these commands to set a port to stack mode, this example uses two 10-GigabitEthernet ports for stacking.
console>enable
console#config
console(config)#stack
console(config-stack)#stack-port tengigabitethernet 1/0/1 stack
console(config-stack)#stack-port tengigabitethernet 1/0/2 stack
console(config-stack)#end
console#copy running-configuration startup-configuration
console#reload
NOTE: You must reboot the switch for ports to transition into stacking mode.
NOTE: You may stack only on the 10-Gigabit
1. Power off the switches. Connect the stacking ports in a ring topology.
2. Power on the desired primary switch first and wait until you can access it. Afterwards power on the next switch one at a time until every switch is powered on. They will add themselves to the stack.
NOTE: The Primary and Operation Standby switches keep the startup-configuration of the stack. You can only access the console port from the Primary.
NOTE: The N1500 series switches support up to 4 units in a stack.
Produits concernés
PowerSwitch N1500 SeriesPropriétés de l’article
Numéro d’article: 000121347
Type d’article: How To
Dernière modification: 18 avr. 2026
Version: 7
Trouvez des réponses à vos questions auprès d’autres utilisateurs Dell
Services de support
Vérifiez si votre appareil est couvert par les services de support.