Dell Unity：由於「目的地集區空間不足 （0x840f）」，複寫未同步

Summary: Dell Unity：由於「目的地集區空間不足 （0x840f）」，複寫未同步 （Dell 可修正）

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

系統已升級至 Unity OE 4.X 程式碼。

升級至 4.4.0.1534750794

異步檔複製無法同步。
Unisphere 錯誤為「無法更新目的地，因為目的地集區已滿」。
但目的地集區會顯示可用容量。

複寫工作階段輸出顯示問題：

*********************************************************************************************************
Session 171798693759_APM0012345678_0000_171798743954_APM0012345679_0000
*********************************************************************************************************
Name = rep_sess_res_27_res_175_APM0012345678_APM0012345679
Session type = file
Synchronization type = auto
RPO = 10m
Resource type = File System
Sync State = idle
Health state = Degraded/Warning (10)
Health details = "The replication session is operating in a degraded state because the storage pool on the destination system has run out of space. Expand the pool to restore normal operation."  <<<<<<<<<<<
Operational status = Destination Pool Out Of Space (0x840f)   <<<<<<<<<<<
Source status = Pool Out of Space  <<<<<<<<<<
Destination status = Pool Out of Space  <<<<<<<<<
Network status = OK
Destination type = remote
Destination system = RS_3
Local role = Source
Source resource = res_27
Source SP-A interface = 192.168.1.1
Source SP-B interface = 192.168.1.2
Destination resource = res_175
Destination SP-A interface = 192.168.1.3
Destination SP-B interface = 192.168.1.4
Time of last sync = N/A
Sync status =
Sync transfer rate = N/A
Sync transfer size remaining = 331786223616 (309.0G)
Previous transfer rate = N/A
Average transfer rate = N/A
Element pairs = N/A
Hourly Snapshot Retention = Hourly snapshots not replicated
Daily Snapshot Retention = Daily snapshots not replicated
Hourly snapshot keep for = not replicated
Hourly snapshot allow auto-delete = not replicated
Daily snapshot keep for = not replicated
Daily snapshot allow auto-delete = not replicated

EMCSystemLogFile.log

A 09/11/19 18:13:06.114 DART_REP 106c0018 [WARN] System: Source=171798693759_APM0012345678_0000_171798743954_APM0012345679_0000(alias=rep_sess_res_27_res_175_APM0012345678_APM0012345679), starting transfer. Destination has no space available. Source is retrying.
Line 3772187: A 09/11/19 18:14:00.656 Health 6077f [WARN] User: Replication session rep_sess_res_27_res_175_APM0012345678_APM0012345679 can not update destination because destination pool is full.

 

Cause

此問題與 Unity OE 代碼 4.X 及更新版本有關。

此問題與非整數大小的檔案系統或快照有關。

升級至 4.4.0.1534750794 時，在 非整數 大小
的現有檔案系統或快照上會出現此問題「無法更新目的地，因為目的地集區已滿」。在升級至 4.4.0.1534750794 之前，使用非整數快照或檔案系統不是問題。

升級後任何新建立的快照或檔案系統都可正常運作。
發生此問題的是升級前建立的非整數檔案系統或快照。

 

Resolution

請聯絡 Dell 客戶支援，並引用此 Dell 知識文章，以取得進一步協助。

將 Unity OE 升級到最新的 GA 5.0，以取得此問題的修正。

 

Affected Products

Dell EMC Unity Family

Products

Dell EMC Unity Family
Article Properties
Article Number: 000055683
Article Type: Solution
Last Modified: 17 أبريل 2025
Version:  5
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.