NVP vProxy：如何手動變更 vProxy 裝置網路介面設定

Summary: 本 KB 概述如何在 NVP vProxy 裝置上手動變更主機名稱和網路設定。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

變更 vProxy 網路資訊的程序會在 NetWorker VMware 整合指南中概述，網址為： https://www.dell.com/support/home/product-support/product/networker/docs （您必須使用 Dell 支援帳戶登入）。

1.開啟連線至 vProxy 裝置的 SSH 工作階段，並使用 admin 帳戶。

注意： 如果無法透過 SSH 連線到 vProxy，請從 vSphere Web 用戶端啟動連線 Web 主控台連線 vProxy。

2.將使用者切換至 root：

sudo su -

3.執行 config_network.sh 指令檔以更新介面設定，將參數更換為您的主機/網路資訊： 

/opt/emc/vproxy/bin/config_network.sh <Interface> <FQDN> <IP Address> <Netmask> <Gateway> <DNS List (comma separated)>

範例：

nsr-vproxy01:~ # /opt/emc/vproxy/bin/config_network.sh eth0 nsr-vproxy01.amer.lan 192.168.9.151 255.255.255.0 192.168.9.1 192.168.9.100
Successfully applied new network settings
active
Restarting network services...
eth0            up
      link:     #2, state up, mtu 1500
      type:     ethernet, hwaddr 00:50:56:be:35:0c
      config:   compat:suse:/etc/sysconfig/network/ifcfg-eth0
      leases:   ipv4 static granted
      addr:     ipv4 192.168.9.151/24 [static]
      route:    ipv4 default via 192.168.9.1 proto boot
Restarting vProxy services...

nsr-vproxy01:~ # cat /etc/sysconfig/network/ifcfg-eth0
DEVICE=eth0
BOOTPROTO='static'
STARTMODE='auto'
USERCONTROL='no'
IPADDR=192.168.9.151
NETMASK=255.255.255.0

nsr-vproxy01:~ # cat /etc/resolv.conf
search amer.lan
nameserver 192.168.9.100
nsr-vproxy01:~ #

4.將 vProxy 裝置重新開機：

reboot

Additional Information

Affected Products

NetWorker

Products

NetWorker Family
Article Properties
Article Number: 000157759
Article Type: How To
Last Modified: 03 يوليو 2026
Version:  12
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.