NVP vProxy：如何手动更改 vProxy 设备的网络接口设置

Summary: 本文概述如何手动更改 NVP vProxy 设备上的主机名和网络设置。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

戴尔支持网站上提供的 NetWorker VMware 集成指南中概述了更改 vProxy 网络信息的过程。（您必须使用您的戴尔支持帐户登录）。

  1. 打开 与 vProxy 设备的 SSH 会话，并使用 admin 帐户
注意： 如果无法通过 SSH 访问 vProxy，请从 vSphere Web 客户端启动到 vProxy 的 Web 控制台连接。

 

  1. 将用户切换到 root中的用户名和密码：
sudo su -
  1. 运行  config_network.sh 更新接口设置（将参数替换为主机和网络信息）的脚本： 
/opt/emc/vproxy/bin/config_network.sh <Interface> <FQDN> <IP Address> <Netmask> <Gateway> <DNS List (comma separated)>

示例：

nsr-vproxy01:~ # /opt/emc/vproxy/bin/config_network.sh eth0 nsr-vproxy01.amer.lan 192.168.9.151 255.255.255.0 192.168.9.1 192.168.9.100
Successfully applied new network settings
active
Restarting network services...
eth0            up
      link:     #2, state up, mtu 1500
      type:     ethernet, hwaddr 00:50:56:be:35:0c
      config:   compat:suse:/etc/sysconfig/network/ifcfg-eth0
      leases:   ipv4 static granted
      addr:     ipv4 192.168.9.151/24 [static]
      route:    ipv4 default via 192.168.9.1 proto boot
Restarting vProxy services...

nsr-vproxy01:~ # cat /etc/sysconfig/network/ifcfg-eth0
DEVICE=eth0
BOOTPROTO='static'
STARTMODE='auto'
USERCONTROL='no'
IPADDR=192.168.9.151
NETMASK=255.255.255.0

nsr-vproxy01:~ # cat /etc/resolv.conf
search amer.lan
nameserver 192.168.9.100
nsr-vproxy01:~ #
  1. 重新启动 vProxy 设备：
reboot

Additional Information

Affected Products

NetWorker

Products

NetWorker Family
Article Properties
Article Number: 000157759
Article Type: How To
Last Modified: 07 أغسطس 2026
Version:  13
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.