CloudBoost: Kontroller NTP-konfiguration

Summary: I denne artikel forklares det, hvordan du kontrollerer NTP-indstillinger for CloudBoost.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

Kontrol af NTP-indstillinger er afgørende for tjenester, der er følsomme over for skævvridning af uret i CloudBoost.
 
NTP-indstillinger kan kontrolleres manuelt i CloudBoost-kommandolinjen (CLI):
  1. Log på CloudBoost CLI med administratorbrugeren.
  2. Kør kommandoen 'diagnostics ntpcheck'.
CloudBoost validerer derefter NTP-indstillingerne og forsøger at synkronisere.
 
Du kan også finde oplysninger om CloudBoost NTP-indstillingerne ved at køre 'diagnostics ntpcheck advanced'.
 
Eksempel:
admin@mag-fs> diagnostics ntpcheck advanced

NTP query details
=================
associd=0 status=c011 leap_alarm, sync_unspec, 1 event, freq_not_set,
version="ntpd 4.2.6p5@1.2349-o Mon Apr 13 13:39:46 UTC 2015 (1)",
processor="x86_64", system="Linux/3.16.0-59-generic", leap=11,
stratum=16, precision=-22, rootdelay=0.000, rootdisp=22443.660,
refid=INIT, reftime=00000000.00000000  Mon, Jan  1 1900  0:00:00.000,
clock=de35fe44.4214ed43  Tue, Feb 20 2018  1:54:12.258, peer=0, tc=3,
mintc=3, offset=0.000, frequency=0.000, sys_jitter=0.000,
clk_jitter=0.000, clk_wander=0.000

remote           refid      st t when poll reach   delay   offset  jitter
==============================================================================
<IP_ADDRESS>   .INIT.       16 u    - 1024    0    0.000    0.000   0.000

Additional Information

Den 'ntpcheck' kommando er kun tilgængelig i CloudBoost 2.1.x og højere.

Affected Products

CloudBoost, CloudBoost Virtual Appliance
Article Properties
Article Number: 000010806
Article Type: How To
Last Modified: 25 ذو الحجة 1447
Version:  5
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.